QNO Security QoS Firewall Router Manuel d'utilisateur télécharger pdf (Page 19)

Configuring Your SmartRG™ - Common Use Cases

Configuring the Layer 2 Interface (ADSL)

To configure an ADSL layer 2 interface:

1. Select Advanced Setup -> Layer2 Interface and click Add.

Figure 12 ADSL Layer 2 Interface Configuration

2. Enter the PVC’s identifier (VPI/VCI).

3. Select the “DSL Link Type” – Ethernet over ATM (RFC 2684) is typical.

4. Select the “Encapsulation Mode” – LLC/SNAP-BRIDGING is typical.

5. Select the “Service Category” (upstream ATM shaping) – “UBR Without PCR” (Unspecified

Bit Rate Without Peak Cell Rate) is typical.

6. Select the “Connection Mode” – Choose Default Mode for non-VLAN tagged traffic. Choose

VLAN MUX Mode if you intend to segment LAN traffic into separate VLAN tagged WAN

services.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 58 59

Pas de commentaire

QNO Security QoS Firewall Router Manuel d'utilisateur Page 19