QNO Security QoS Firewall Router Manuel d'utilisateur télécharger pdf (Page 47)

Configuring Your SmartRG™ - Common Use Cases

5. Name, enable and select the WAN interface to be fed by this queue.

IMPORTANT

NOTE

Select the routed WAN interface created in the “Creating the WAN Service” section.

6. Select a “Precedence” of 1.

NOTE

Lower values of “Precedence” indicate HIGHER priority.

7. Leave the “DSL Latency” value set to Path0 and Click Apply/Save.

8. Create the IPTV queue by selecting Advanced Setup -> Quality of Service -> QoS Queue

Config and click Add.

Figure 39 QoS: IPTV Queue Configuration

9. Name, enable and select the WAN interface to be fed by this queue.

IMPORTANT

NOTE

Again, select the routed WAN interface created in the “Creating the WAN Service”

section.

10. Select a “Precedence” of 2.

NOTE

IPTV traffic should be of LOWER priority (HIGHER Precedence value) than VoIP traffic.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 58 59

Pas de commentaire

QNO Security QoS Firewall Router Manuel d'utilisateur Page 47